Teka LSE-1200 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
20
3.Do not place heavy objects or container
with water on the washing machine,so as to
prevent deformation of the flat surface and
plastic parts.
4. Do not wash articles containing
polystyrene or similar elastic materials.
5. Before washing, do up zippers and ensure
that buttons are securely fastened. Place
small items, such as socks,belts,etc. in a
small washing bag or a pillow-case . To
protect the washing machine, do not wash
garments containing wire parts.
7. The door is fitted with a self-lock device
and can not be opened until 2-3 minutes
after the end of the programme.You are not
recommended not to force the door open
before the programme end. Do not open the
door if the water level is above the lower
part of the door.
8. At the end of the wash cycle, turn off the
water supply to prevent water leakage, un-
plug the washing machine and thoroughly
clean the trim so as not to dirty the laundry
in the next wash cycle.
Precaution
6.Do not open the detergent drawing
during the wash cycle.
9.For appliances with type Y attachment,the
intructions shall contain the substance of the
following.
If the supply cord is damaged,it must be
replaced by the manufacturer,its service
agent or similarly qualifled persons in order
to avoid a hazard.
10.The installation instructions shall state
that the appliance is to be connected to the
water mains using new hose-sets and that
the old should not be used.
For washing machines with ventilation
openings in the base,that a carpet must not
obstruct the openings.
Trouble-shooting
The following problems are not always caused by faults, Before calling the Service
Center, please
check to see if the faults can be self-corrected.
Problem
Possible cause
l
Poor connection to power supply
l
Power failure
l
Door is not properly closed (Err 1)
l
The machine is not switched on
.
l
Water tap is not turned on
l
Water pressure is less than 0.05Mpa
l
The inlet hose is kinked
l
Water supply failure
l
The program knob is not properly set
l
The door is not properly closed
The machine is draining while is
being filled
l
The height of the drainage hose is below 80cm (it
should be within 80
-
100cm)
Drainage failure
l
Drainage hose is blocked
l
Drainage hose end is below 100cm above the floor
level
l
The filter is blocked
Strong vibration during spinning
l
Not all packing bolts have been removed
l
Washing machine is located on an uneven surface or is
not level
l
Machine load is over 6kg.
Operation stops before completion
of a wash cycle
l
Water or electricity failure
l
Washing machine is in a soaking cycle
l
Washing machine gives an error message.
Excessive foam in the drum, which
is spilled to the distribution drawer
l
The detergent is not a low
-
foaming type
l
Excessive use of detergent
The washing machine does not start
Washing machine cannot be filled
with water
Page view 5
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments