Teka TB 600 User's Guide download pdf (Page 28)

Viewing / Changing the programmed

time

To view on the clock indicator (8) the time

left before the hotplate turns off, you only

have to select the hotplate required, both

the decimal point (13) and the control pilot

light (11) which corresponds to the selec-

ted hotplate will turn on.

If you wish to change the time left, follow

the steps below:

1 The hotplate that is to be controlled must

have already been selected. Both the

decimal point (13) and the control pilot

(11) which corresponds to the selected

hotplate must be on.

2 Touch the clock sensor (7). The deci-

mal point (13) for the clock will come on.

3 Use the or sensors (5/4) to alter

the time.

Alternatively you can directly touch the

clock sensor (7) various times until the

control pilot (11) for the hotplate required

comes on. You can then also change the

time, if required, using the sensors or

(5/4).

Disconnecting the clock

When the time that was programmed for

the hotplate elapses, a series of beeps will

sound for at least a minute.

To stop the beeping, touch any sensor.

The hotplate will now be disconnected.

If you wish to stop the clock before the

time programmed has elapsed:

1 The hotplate that is to be controlled must

have already been selected. The deci-

mal point (13) and the pilot light for the

selected hotplate (11) must be on.

2 Touch the clock sensor (7). The deci-

mal point for the clock (13) will come on.

3 Use the sensor (4) to decrease the

time to 00.

Quick switch-off

Repeat steps 1 and 2 above.

3 Touch sensors and (5 and 4) si-

multaneously and the clock will be dis-

connected.

The clock will have been cancelled, but the

hotplate will still be active until you switch

it off.

MODELS TC 620, TR 735 AB AND TR 641

On these models, you can use the clock as

a countdown timer for periods between 1

and 99 minutes, and as a hotplate timer for

times between 1 and 99 minutes. All the

cooking areas can be programmed inde-

pendently and simultaneously.

Timing a hotplate

1 The cooking area to be timed has to be

selected. The corresponding decimal

point (13) must be lit.

2 Select a power level of between 1 and 9

using the or sensors (5-4).

3 Touch the clock sensor (7). The deci-

mal point (13) of the time display (8)

(which shows 00) will come on, and it

will flash on and off along with the con-

trol display (11) of the corresponding

area.

4 Touch the clock sensor (7) again to

increase the value of the time you wish

GB

28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 38 39

Comments to this Manuals

No comments